您在使用过程,发现BUG通过在线问题提交由开发人员确定后,本站将会给予一个月广告展示机会!
 位置:首页 -> 招商 -> 工程机械 -> 其它工程机械  
 招商产品信息   发布招商 
招商标题: 10千瓦静音柴油发电机如何启动
招商代理模式: 授权代理
招商地区: 电议
对代理商要求: 电议
提供的支持: 电议
行业分类: 工程机械->其它工程机械
移动分享:
微信分享
详细信息:  
10千瓦静音柴油发电机如何启动柴油发电机组启动前的准备:
1.检查润滑油的油位、 冷却液液位、燃油量;
2.检查柴油机的供油、润滑、冷却等系统各个管路及接头有无漏油漏水现象;
3.检查电气线路有无破皮等漏电隐患,接地线电气线路是否松动,机组与基础的连接是否牢固;
4.若环境温度低于零度时,须在散热器内添加一定比例的防冻剂;
5.柴油发电机组次启动或停机较长时间后再次启动,应先用手压泵排尽燃油系统内的空气。
【品牌名称】:豹罗动力
【销售经理】:宋经理
【联系电话】:18019419802(同微信)
【直线座机】:021-51987469
【电子邮箱】:1736462533@qq.com
【公司名称】:上海豹罗实业有限公司
【在线QQ】:1736462533
【公司地址】:上海嘉定区叶城路818号


启动:
1.合上控制箱内的保险后,按启动按钮,按下按钮3~5s,若启动不成功,应等20s左右再次启动。若多次启动不成功,应停止启动操作,排除电瓶电压或油路等故障因数后,再次启动;
2.启动时应观察几油压力,若油压无显示或很低时,应立即停车检查。
运行:
1.机组启动后,检查控制箱模块各项参数;机油压力、 水温、电压、频率等;
2.通常情况下,机组启动后转速直接达到额定转速;有怠速要求的机组,怠速时间一般为3~5min,怠速时间不易过长,否则可能烧坏发电机相关元器件;
3.检查机组油路、水路及电器的渗漏情况;
4.检查机组各连接处的紧固情况,看有无松动和剧烈振动;
5.观察机组各种保护和监视装置是否正常;
6.当转素达到额定转速,起空载运行的各项参数稳定后,合闸供电;
7.检查确认控制屏各项参数是否在允许的范围内,再次检查机组的振动,有无三漏及其他故障;
8.机组运行时严禁超载。




Preparation of a diesel generating set before starting:
1. check the oil level, coolant level and fuel volume of the lubricating oil.
2. check whether there is leakage or leakage of oil and lubricating oil and cooling system in the diesel engine.
3. check whether there is leakage hazard such as broken electrical wiring, whether the electrical wiring of the grounding wire is loose, and whether the connection between the unit and the foundation is solid.
4. if the ambient temperature is below zero, a certain proportion of antifreeze should be added to the radiator.
5. diesel engine generator start or stop after a long time to start again, should first use the hand pump to exhaust the air in the fuel system.


brand name: Leopard power
sales manager: manager of song
contact: 18019419802 (with WeChat)
linear machine: 021-51987469
E mailbox: 1736462533@qq.com
Company name: Shanghai leopard Industry Co., Ltd.
online QQ: 1736462533
company address No. 818 Yecheng Road, Jiading District, Shanghai.




Start:
1. close the control box's insurance, press the start button, press the button 3~5s, if the start is not successful, wait for 20s to start again. If multiple start-up fails, the operation should be stopped and the fault factors such as battery voltage or oil circuit should be removed.
2. several oil pressure should be observed when starting. If the oil pressure is not shown or very low, stop checking immediately.
Function:
1. after the unit starts, check the parameters of the control module, oil pressure, water temperature, voltage, frequency, etc.
2. normally, the speed of the unit is directly rated as the speed of the set. The idle speed is generally 3~5min and the idle time is not easy to be too long, otherwise the generator related components may be burned.
3. check the leakage of oil, water and electrical equipment.
4. check the fastening position of each connection point to see if there is loose or violent vibration.
5. observe whether the various protection and monitoring devices are normal.
6. when the converter reaches the rated speed, the various parameters of the no-load operation will be stabilized and the power supply will be closed.
7. check to see if the parameters of the control panel are in the allowed range, check the vibration of the unit again, whether there are three leakage and other faults.
Overloading of the 8. unit is strictly prohibited.
产品规格: 手机:18019419802
产品型号: YOMO-10GT-2
市场价格: 面议! 元(人民币)
会员价格: 面议! 元(人民币)
年 产 量: 9888885
 上海豹罗实业有限公司
张婷  女士 |   经理
手机: 15692173681
电话: 86 - 021- 51987457
传真: 86 - 021- 51987457
地址: 上海市嘉定区菊园新区环城路2222号1幢J1881室
邮编: 0
网址: 访问企业网站
0
代理留言:
(最多500汉字)
联系人: 联系电话:
人工验证:
(过滤机器人群发)
    
网站首页 - 关于我们 - 使用协议 - 免责条款 - 版权隐私 - 网站地图 - 友情链接 - 广告服务 - 会员服务 - 免费注册 - 联系方式
问题请通过在线提问反馈 | 在线客户QQ:105452034 | 收费会员及广告咨询电话13332201705 技术支持:辽宁衡骏节能科技有限公司
Copyright 2007- dbzz.net All Rights Reserved 东北制造网(东北地区唯一制造业网上平台) 版权所有 辽ICP备2021008091号 辽公网安备21021702000105
为获得最佳浏览效果,建议使用IE7以上,或Firefox7以上浏览器
经营性网站
备案信息
百强网站
诚信联盟
网络110
报警服务
不良信息
举报中心